Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-14-2006, 03:41 PM
|
#3 |
|
Registered Member
Join Date: Nov 1998
Location: Houston, Tx.
Posts: 3,887
|
Re: help with inline 6
Or could be the opposite problem (not enough accelerator pump shot) causing a lean bog when you give it the gas. Either way, it's most likely a carburetor problem. Rebuild it yourself or buy a quality rebuilt carb and install it. Could be as simple as a ripped diaphram in the accelerator pump (easy to fix).
Look down the carb bore with the engine off. Operate the carb linkage by hand to WOT. There should be a good steady stream of gas from the accerator pump nozzles (shooters) near the top of the carb. If not, then you know where the problem lies. Rev
__________________
'66 Coupe, 306, 350-375 HP, C-4, 13.07 e.t., 104.8 mph, 1/4 mi. O.B.C. #2 '66 coupe |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fuel Regulator,or inline pump | johnwb | Windsor Power | 5 | 10-27-2005 03:40 PM |
| inline pump recommendations | MJ86GT | Windsor Power | 1 | 09-17-2004 08:15 AM |
| intank or inline fuel pump? | zepherman | Windsor Power | 9 | 08-10-2002 04:28 PM |
| 3.3 inline 6 upgrades | digital3.3 | Small Ponies | 0 | 04-17-2002 04:07 PM |
| inline 6 hp | fordkid68 | Small Ponies | 0 | 03-13-2002 03:00 AM |