Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-07-2006, 07:48 AM
|
#14 |
|
Rat Killer
Join Date: Aug 2002
Location: Cold ass Ohio
Posts: 1,143
|
Re: converting to 4 corner idle...worth it?
Denny,
17 posts to date, and I've seen about 10 of them. Seems like you know what you're talking about, and I think you'll bring some good info to us and this board. Welcome aboard! Brian, I like the 4 corner idle adjustment just for the simple fact that you can "dial in" the carb alot better. As a matter of physics, the 4 corner cylinders (1-4-5-8) tend to be a bit "lean", and idle screws on the back help out #4 and #8. Again, just my $.02, but PKRWD is the resident Holley Guru! When the Scarelane is done, I'm sending my 850 to his house! 
__________________
d-Con Racing "Nothing fancy, just 347 inches of RAT POISON!" MICE need not apply..... 
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Idle Problems | BluBisiro | Modular Madness | 4 | 04-18-2005 01:37 PM |
| Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
| Problems with TFS engine combo..wont idle right and sputters when you give it throttl | dashapht | Windsor Power | 8 | 07-17-2001 12:23 AM |
| I am over the idle deal | TomEboi | Modular Madness | 3 | 03-24-2001 03:57 PM |
| 2.3 idle | matt cook | Small Ponies | 1 | 08-02-1999 04:22 PM |