Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
12-05-2006, 08:33 AM
|
#10 |
|
Registered Member
Join Date: Mar 2000
Location: minneapolis, mn
Posts: 158
|
Re: Full Length Sub Frames???
at this point im trying to decide between the BMR, MAIER and Maximum Motorsports full length subframes. THE MM are about $150 where as the other 2 are around 250.....
I think the BMR look the strongest but i have emailed tech support there to see if there is any loss in ground clearance.
__________________
1991 LX coupe,AOD, red, 80k, K&N, MAC cat back, MAC off-road X, Autometer Gauges, BBK Ceramic unequals, fully polished upper intake, fuel rails, and egr, working on installing.....MM full length subs, H&R sport springs, MM Lower control arms, MM caster camber plates, bilstein shocks, struts. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Subframe connectors, full length vs. standard | flyin 5.8 | Windsor Power | 2 | 10-01-2002 09:41 AM |
| Full length or shorties? | Nicodemus | Small Ponies | 5 | 08-04-2002 10:55 AM |
| MM subframes....standard or full length? | DemonGT | Windsor Power | 3 | 04-22-2002 09:38 AM |
| 5-inch full length hood? | 429mustang | Blue Oval Lounge | 1 | 11-04-2001 01:39 PM |
| full length or standard length subframe connectors? | 84stangLX | Windsor Power | 4 | 04-23-2001 03:48 PM |