

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
Registered Member
Join Date: May 1999
Posts: 5,246
|
![]() I'm not necessarily telling you to swap the setup out. You'll need a dyno to tell you which system is actually delivering better performance throughout your powerband. The "seat of the pants" meter is unlikely to be able to accurately analyze your cars true performance between the two.
Of course, if you're happier with one than the other, that's the ultimate test, isn't it? |
![]() |
![]() |
![]() |
#2 |
Registered Member
Join Date: Mar 2007
Posts: 4
|
![]() I did the same changed out the factory cats for the offroad h-pipe mated to 2.5 flowmaster. THe car runs like a champ but is running real rich from inside the car I can smell gas fumes. Do I need make adjustments to my fuel regulator( AmFlo ).
Has anybody heard of AmFlo fuel regulators?
__________________
![]() |
![]() |
![]() |
![]() |
#3 |
Registered Member
Join Date: Jun 2002
Location: Portage
Posts: 239
|
![]() You would have to have a air fuel gauge to tell that. My car smelled rich too, your smelling the unburned gas thats being sucked out of the cylinder.
__________________
'95 GT convert. K&N, C&L mass air meter, Performance distributors sreamin demon coil, dyna mod, live wires, king cobra clutch, flowmaster american thunder exhaust, UPR billet adjustable shift handle, Crane Cams Fireball HI-6 box,underdrive pullies, 255lph fuel pump, UPr short throw shifter, caster camber plates, 03 cobra lower A arms, bullit suspension, cobra front brakes |
![]() |
![]() |
![]() |
#4 | |
Registered Member
Join Date: Mar 2007
Posts: 4
|
![]() Quote:
have a Accel guage coming in the mail. Sounds like both our cars have about the same mods what PSI should I be running?
__________________
![]() |
|
![]() |
![]() |
![]() |
#5 |
Registered Member
Join Date: Nov 2006
Location: Naples FL
Posts: 106
|
![]() about a fuel pressure reg....whats a good one and what do i have to do to install it...i'm thinking i have the same problem to...
__________________
ZEX ![]() ![]() |
![]() |
![]() |
![]() |
#6 |
Registered Member
Join Date: Mar 2007
Posts: 4
|
![]() BBK makes a good one. Summit Racing has instructions how to install one. I wound spend extra $55 buck and buy the fuel pressure gauge
__________________
![]() |
![]() |
![]() |
![]() |
#7 |
Registered Member
Join Date: Apr 2001
Location: Gallatin, Tn
Posts: 1,326
|
![]() BBK has a high rate for rebuild requirements on their regulators, just my .02 cents. Aeromotive sells a good one IMO
__________________
![]() Last edited by USMC302; 03-21-2007 at 11:50 AM.. |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Back pressure measurement? | Rev | Windsor Power | 3 | 10-08-2003 10:13 PM |
Back pressure | Nicodemus | Small Ponies | 1 | 02-11-2003 07:48 PM |
Fuel pressure regulator..proper way to set pressure... | Reipen | Windsor Power | 0 | 05-27-2002 01:41 PM |
Back pressure good or bad? | RAGE_5.0 | Blue Oval Lounge | 8 | 11-23-2001 02:00 PM |
Eanough Back Pressure???? | BowTie Eater 5 Liter | Windsor Power | 1 | 04-08-2001 08:32 AM |