Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-07-2001, 09:21 PM
|
#2 |
|
Registered Member
Join Date: Sep 2001
Location: Grand Rapids, Michigan, USA
Posts: 50
|
Rebuild that darn thing its probably a ring. Its 17 years old! Get a valve job done on the heads if you deside not to get new ones.
------------------ Joe Zemaitis, Grand Rapids Michigan 1991 Mustang GT. Mods to date: 4.10 rear end, new POSI, aluminum driveshaft, AOD w/ shift kit, 2 1/2 off road h-pipe, 2 1/2 flowmasters and 2 1/2 tail pipes. Electric fan, Removed air pump and egr tube. Hotchkins upper and lower control arms. New energy suspension rear busings. Hoosier Quick Time Pro 27x10.5x15 and bolt on subframes soon to be welded. Everything else is STOCK. Totally stock ENGINE. 14.29@96 with 130k miles. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Piston Ring Install Question | rancheroo | Windsor Power | 3 | 02-20-2004 10:07 PM |
| Any piston to valve clearance prob with AFR 165's? | 5ohCOUPE | Windsor Power | 2 | 03-09-2003 12:39 AM |
| Piston to bore measurements | zach0 | Classic Mustangs | 1 | 01-26-2003 04:03 PM |
| Piston Speed | richd | Windsor Power | 1 | 10-12-2002 10:11 AM |
| valve seal vs piston ring oil leak. | thdrcat | Classic Mustangs | 2 | 07-30-2002 07:06 PM |