Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-28-2009, 07:13 PM
|
#4 |
|
Registered Member
Join Date: Mar 2000
Location: Berwick,Pa
Posts: 127
|
Re: buying an older paxton blower fri?
impulse won! i bought it so i'll let you guys know how i make out. from the serial number i am assuming it is a sn92 model. everything is there for installation. i already have a 76mm c&l mass air meter and 30 lb injectors. do i need to use the fmu with this? also do i need to change my spark plugs. what are some good boost guages to run? thanks guys you always have good advice.
__________________
'89 GT hatch back performer rpm intake, performer rpm cylinder heads, fms e-303 cam, kirban adj fp regulator, holley 65mm tb, harland sharp 1.6 roller rockers, alum driveshaft, 3.73 gears (283 rwhp, 303 rwtq new numbers with new heads) |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Older model Paxton | mrclean27_72 | Power Adders | 3 | 05-17-2005 03:52 AM |
| older GT to V6 LCAs, possible? | Alpha | Corner Carvers Delight | 2 | 04-08-2005 11:49 PM |
| Newer Car/older Motor | DANNER | Windsor Power | 0 | 03-26-2003 04:33 PM |
| Oil return line on blower? (Vortech or Paxton only) | buddha | Windsor Power | 2 | 03-12-2001 07:58 PM |
| Roller cam for older motors??? | rwhite65 | Classic Mustangs | 1 | 04-12-1999 11:04 PM |