Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-08-2009, 04:52 PM
|
#3 |
|
Registered Member
Join Date: Mar 2004
Location: Minnesota
Posts: 950
|
Re: Part interchange?? 289/5.0??Heads??
Yeah I was going to say that if they do bolt up (Which im pretty sure they should, I dont see why they wouldnt, though I wasn't 100% sure so I didn't post) they will have a lower C/R than the old heads. Look at the casting numbers in the heads and you should be able to google the combustion chamber size and compare.
I still think it would be best to just drop the 5.0 in there. You could still run a carb, just swap out the intakes. The 5.0 will have a roller cam and revised firing order. You would also have to install a fuel pump eccentric. I would imagine the 289 cam cover would swap over to the 5.0. Mustangs Plus - Tech Articles - Project EFI GT (Page 1) That is a pretty good article on swapping over to EFI.
__________________
Alex |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| flexplate interchange | 69351w | Classic Mustangs | 4 | 10-30-2003 02:21 AM |
| which t-tops interchange? | stng87 | Windsor Power | 4 | 04-08-2002 08:30 PM |
| T-Bird SC parts interchange | S Howard | Blue Oval Lounge | 1 | 09-05-2001 09:00 PM |
| 302 and 351W starters...interchange? | 82 GT | Windsor Power | 1 | 08-22-2001 11:36 AM |
| steering Box interchange for 72 | thunderbolt | Classic Mustangs | 0 | 06-10-2000 02:26 PM |