Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
10-14-2001, 11:14 AM
|
#1 |
|
Registered Member
Join Date: Jan 1999
Location: Clayton, North Carolina, USA
Posts: 803
|
I don't have the same set up as you but....you may be able to slightly modify the stock valve covers to clear the rockers.
I have a GT-40 intake with Lunati aluminum roller rockers and had a clearance problem. I was able to remove the oil baffle at the filler neck opening, grind the bosses off and then I ground the other ribs in the casting where there was a clearance problem. This allows the use of the stock covers. I suspect you will need a 1" spacer to get the clearance you need for the tall motorsport covers. Not sure about the Holley intake but I have seen this done with an Edelbrock intake and stock hood. Hope that helps some ------------------ fordgasm CLICK HERE to see my 87 GT |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Any rocker arm valve cover clearance probs with TFS TW heads? | 5ohCOUPE | Windsor Power | 2 | 03-14-2003 09:42 PM |
| Valve Cover Clearance With Holley Systemax | Mustang_GT_90 | Windsor Power | 2 | 12-21-2002 10:40 AM |
| Valve cover baffles and rocker clearance... | Hozer 88GTConv | Windsor Power | 1 | 11-10-2002 01:26 PM |
| valve cover clearance | Blownpony91 | Windsor Power | 2 | 10-31-2001 04:48 PM |
| Valve cover clearance with 1.6 RR on TFS heads | sedanman | Windsor Power | 2 | 08-19-2001 08:58 PM |