Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-20-2001, 10:10 PM
|
#2 |
|
Registered Member
Join Date: Dec 2000
Location: roseburg, oregon
Posts: 87
|
How big are the jets that you have in it now? It really sounds like you're jetted way too fat. Go down on your jet sizes 4 at a time. I have a Holley 3310(750 vac. sec.)on my '79 stang driver now. That was my problem. Mine acted the same way you're describing. I've got size 66's in the primary and it is a little bit on the rich side but I'd rather have it a little rich than too lean. When I adjust my air/fuel screws, I'm at 1 1/2 turns where it runs the best.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| what if any problems with your Modular Model Gt/Cobra? | fixer | Modular Madness | 18 | 04-03-2005 09:18 AM |
| Sick 88 Gt Computer problems? | ziggy_2k | Windsor Power | 5 | 06-02-2002 10:33 PM |
| '65 - Pull Away Problems - Action Plan | geordie | Classic Mustangs | 0 | 05-14-2002 01:43 PM |
| Well I did a compression test and it doesn't look goo for my Holley heads... | Rick 91GT | Windsor Power | 6 | 02-20-2001 07:43 AM |