Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-18-2001, 07:50 AM
|
#5 |
|
Registered Member
Join Date: Jan 2000
Location: Feeding Hills, MA
Posts: 114
|
I think I found out why I have been going through so many TFI Modules. My coolant temp stays constant around 180, but I had a large amount of heat coming from the engine itself. To the point where you couldn’t put your hand on the upper intake it was that hot. I pulled the distributor after it was idling and it was almost too hot to handle.
I think I have found the problem the drivers side header flange is hitting the block where one of the bell housing mounting bolt are, it actually burned a hole in the header flange. I am going to trim as much off the flange as possible and try to remove the excess flashing off of the block. The headers are MAC shorties, looking for a ceramic shorty replacement, NE1 want a set of 351 headers cheep before I do some trimming? Do you think this was causing the excess temperatures in my engine? |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| TFI module vs Ignition module | teallighting | Windsor Power | 1 | 03-21-2004 03:38 AM |
| Another TFI Module Failure | NO SLO PK | Windsor Power | 5 | 12-24-2003 11:39 AM |
| Fuel Pump or TFI Module ??? | mimicons | Windsor Power | 1 | 05-13-2003 02:35 AM |
| Best place to mount an ignition module? | Blue Beast | Windsor Power | 4 | 03-16-2002 01:19 PM |
| Damn wrecker guy lost my alarm module..... | blowncobra | Windsor Power | 2 | 03-15-2001 11:03 PM |