No spark=Engine not running..How can I tell if I got spark???

PKRWUD · 10-23-2001, 01:24 PM

Have him try and start it. After 10 seconds of cranking it over, have him pull a spark plug and see if it's wet. If it's dry, it's a fuel problem. If it's wet, he needs to verify spark. While the plug is out, attach it to the plug wire and rest it on the intake. Crank it over and look for a spark. If there's a spark, he needs to verify the ignition timing by setting it at TDC after the compression stroke, and verify the rotor position. If there's no spark, he needs to verify the coil is working. This can be done the same way he checks to see if the plug is firing (attach a plug to the coil wire, and ground it by resting it on the intake). If the coil is working, he needs to inspect the cap and rotor for damage. If the coil is not firing, he needs to check the TFI module. The easiest method is to replace it with a known good module.

Replace parts as deemed defective.

Take care,
-Chris

------------------
Retired Moderator
MustangNet

My site: Peckerwoods Pit Stop

My teams site: Jim Porter Racing

RACECAR spelled backwards is RACECAR

HEY !!! Are you ASE Certified ??? If you are, ask me about iATN.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Car running lean, any suggestions?	MATTKNIGHT	Windsor Power	10	03-08-2009 03:52 PM
replaced spark plugs, now car runs like ****	cavdo	Modular Madness	10	12-31-2002 05:49 PM
Spark plugs are white! Running lean? how to adjust timing?	1jimmy__d	Windsor Power	7	08-01-2002 05:29 PM
Car's running hot...	Sonics2042	Windsor Power	8	07-16-2002 04:50 PM
Have Fuel NO SPARK!	Tony91LX	Windsor Power	5	06-21-2001 05:55 AM

10-23-2001, 01:24 PM	#10
PKRWUD Junior Member Join Date: Mar 1999 Location: Ventura, California Posts: 8,981	Have him try and start it. After 10 seconds of cranking it over, have him pull a spark plug and see if it's wet. If it's dry, it's a fuel problem. If it's wet, he needs to verify spark. While the plug is out, attach it to the plug wire and rest it on the intake. Crank it over and look for a spark. If there's a spark, he needs to verify the ignition timing by setting it at TDC after the compression stroke, and verify the rotor position. If there's no spark, he needs to verify the coil is working. This can be done the same way he checks to see if the plug is firing (attach a plug to the coil wire, and ground it by resting it on the intake). If the coil is working, he needs to inspect the cap and rotor for damage. If the coil is not firing, he needs to check the TFI module. The easiest method is to replace it with a known good module. Replace parts as deemed defective. Take care, -Chris ------------------ Retired Moderator MustangNet My site: Peckerwoods Pit Stop My teams site: Jim Porter Racing RACECAR spelled backwards is RACECAR HEY !!! Are you ASE Certified ??? If you are, ask me about iATN.