Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-23-2001, 11:24 PM
|
#5 |
|
Registered Member
Join Date: May 1999
Posts: 5,246
|
So you'd like to compare the Dart Srs with the TFS TW stuff? The iron heads will cause you problems with detonation, preignition if you go too high on the CR. The aluminum heads will require a good cooling system but be less finicky.
The Sr's flow very very linear. TFS flow a much better curve. Personally, I'd rather have the streetability of the aluminum heads. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Head swap question | shoyoas | Modular Madness | 2 | 05-02-2003 07:48 AM |
| Head swap question | Badass_yellowGT | Modular Madness | 11 | 11-04-2002 11:19 PM |
| Quick question!!..taking head off | bobtodd | Windsor Power | 3 | 09-13-2002 04:20 PM |
| head bolt question... | avbcon12 | Windsor Power | 4 | 02-23-2002 09:13 AM |
| Head Gasket question | slo95 | Windsor Power | 3 | 05-01-2001 04:32 PM |