Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-29-1999, 11:08 PM
|
#2 |
|
Registered Member
Join Date: Mar 1999
Location: WY
Posts: 41
|
We to have an "M" code 69 Mach 1.
Our heater hoses are as follows... The upper hose on the firewall goes to the water pump. (the lower of the two pump connections) and the lower firewall connection goes to the Intake manifold on top by the radiator hose. The uppermost (of the small) water pump connections is connected to the front of the intake manifold at the thermostat cover with a short 90 degree (angle) hose. Hope this helps. PS. Is your factory intake cast iron or aluminum? ------------------ |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| '69 heater hose connections - please advise | 69Mach1 | Small Ponies | 1 | 01-20-2008 10:38 AM |
| Heater hose fitting w/ECT mount ??? | Chris in NY | Windsor Power | 2 | 05-30-2003 04:34 PM |
| P/S bracket and hose | mike34cpe | Classic Mustangs | 0 | 11-04-2002 08:58 PM |
| 351C-best way to remove heater hose nipple from block? | 351WCapri | Windsor Power | 1 | 05-30-2001 12:41 AM |
| Heater Problem | Elvis | Classic Mustangs | 3 | 10-21-2000 10:22 PM |