5800 RPM on a Cleveland?

mach72 · 07-04-1999, 12:35 AM

The stock multi-groove valves are not to be used for high rpm use. They grip the valve stem loosely(to allow the valve to rotate for even stem wear) and have been known to cause "dropped valves". I have experienced this on an engine that was never pushed past 5500 rpm. I dropped a valve, put a hole in the top of the piston and cracked the block. This was while cruising along at a leisurely pace and not while racing. Although 2 years of hard use and street/strip duty played a part. The stock exhaust valves are of a 2 piece design and have been known to seperate under high spring pressures. I am presently rebuilding a cleveland for my 72 mach 1 and I am using stainless valves with single grooves and a completely new valvetrain. I feel that I have spent too much money on machine work to take a chance with the stock multi-groove valves. The stainless single groove valves can be purchased for about $200 from any mail order supplier or your local machine shop. Good luck, Tom

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
GM Engines	BLOCKER	Blue Oval Lounge	2	04-13-2004 12:35 AM
Speed Secret # 3	jim_howard_pdx	Windsor Power	13	11-09-2002 10:35 AM
Edelbrock RPM Package	jim_howard_pdx	Classic Mustangs	2	10-28-2002 04:57 PM
Experience with Edelbrock RPM Package	jim_howard_pdx	Windsor Power	0	10-27-2002 01:10 AM
Performer RPM vs RPM Air Gap	Phantom5oh	Windsor Power	17	01-10-2002 04:19 PM

07-04-1999, 12:35 AM	#1
mach72 Registered Member Join Date: Apr 1999 Location: Bixby, Ok USA Posts: 8	The stock multi-groove valves are not to be used for high rpm use. They grip the valve stem loosely(to allow the valve to rotate for even stem wear) and have been known to cause "dropped valves". I have experienced this on an engine that was never pushed past 5500 rpm. I dropped a valve, put a hole in the top of the piston and cracked the block. This was while cruising along at a leisurely pace and not while racing. Although 2 years of hard use and street/strip duty played a part. The stock exhaust valves are of a 2 piece design and have been known to seperate under high spring pressures. I am presently rebuilding a cleveland for my 72 mach 1 and I am using stainless valves with single grooves and a completely new valvetrain. I feel that I have spent too much money on machine work to take a chance with the stock multi-groove valves. The stainless single groove valves can be purchased for about $200 from any mail order supplier or your local machine shop. Good luck, Tom