Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-31-1999, 03:21 PM
|
#3 |
|
Registered Member
Join Date: Oct 2000
Location: canada
Posts: 1
|
I agree on the 2 1/2 on the way back. Use a crossover pipe. I prefer the 3 chamber Flowmaster with offset inlet [gets you around the driveshaft] and a center exit. Try and get mandral bent tail pipe where they go over the rear axle housing. Also, long headers, again I prefer Hooker's, they fit.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Speed Secret # 4 | jim_howard_pdx | Windsor Power | 13 | 11-10-2002 03:42 PM |
| Speed Secret # 3 | jim_howard_pdx | Windsor Power | 13 | 11-09-2002 10:35 AM |
| Header gaskets | Stang951 | Windsor Power | 18 | 11-01-2002 05:57 PM |
| 99 V6 Dual Exhaust Conversion | Josh91 | Small Ponies | 1 | 06-17-2000 08:44 AM |
| duel exhaust conversion | 289Eric | Classic Mustangs | 1 | 06-28-1999 09:45 AM |