Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-27-2000, 07:01 PM
|
#2 |
|
Registered Member
Join Date: Dec 1998
Location: Tampa, FL
Posts: 70
|
I looked at your entry in Users Rides which
lists your engine as a stock 289 2v. It should have hydraulic lifters. Turn engine by hand until the piston is at TDC on compression stroke. Adjust rocker untill all play is removed from the push rod (twisting the pushrod helps). Then turn adjusting nut 1 and 1/2 more turns. Repeat for all cylinders. Hope you havn't damaged anything. Good Luck, Lou |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dont use 1.7 rockers with stock heads? | Coupe5oh | Windsor Power | 10 | 11-28-2015 12:36 PM |
| Noise rockers Help?????? | 393Clevor | Windsor Power | 5 | 07-21-2003 06:44 AM |
| Rail Rockers on 289 Small Block Heads | sleeperstang | Classic Mustangs | 16 | 05-11-2003 11:34 PM |
| Roller Rockers, bad? | HiFlow5 0 | Windsor Power | 1 | 04-14-2002 01:35 PM |
| reg rockers or roller rockers?? | Chevysucks | Windsor Power | 1 | 12-05-2001 08:17 PM |