Dyno tune and chip

[95snake]

Eric, it is costing me $650.00, that is for the cost of the chip ($275.00) and all the dyno time I need and labor. Also, the guy will drive up here to Norfolk, burn a new program for only $50.00 if I change something in the engine!!!
Yes, the are going to hook up a air/fuel to make sure it is right. I hope this makes a big differance, I think it will, my car just doesn't seem to be running like it should.

------------------
95 Cobra, 9LB Powerdyne, Forged Pistons, Twisted Wedge heads, 70mm TB, Bullet 75mm Mass-air,
TFS 1.7 rockers,
38lb injectors, Roller Timing Chain, Stewart Water Pump, High Flow Oil Pump, B&M Ripper,
SVO HD clutch, 255lph,
Full MSD system w/BTM, MAC Headers,MAC H-pipe w/cats, 3:55's,By-pass valve, Incon Check Valves,Sub-frames, Driveshaft loop, Fuel pressure regulator, flowmasters, A-pillar gauge, intake spacer.