Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-27-2001, 04:24 PM
|
#9 |
|
Registered Member
Join Date: Apr 2000
Posts: 102
|
you will be able to notice the amount of torque gained from boring it .060 over. I sure did. can sit there and roast them now. You will like it alot better than stock. if you put some flat tops pistons in it you will gain horsepower b/c of the raised compression.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GT40 crate engine question | dlb1982 | Windsor Power | 2 | 09-24-2002 09:42 AM |
| Question about rebuilding engine | setherek | Classic Mustangs | 3 | 09-22-2002 10:41 PM |
| Boring question..but need advice | tluv302 | Windsor Power | 3 | 03-06-2002 04:09 PM |
| Engine Shifting into radiator and also clucth broke | Stuffie0912 | Classic Mustangs | 2 | 12-03-2001 03:26 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Small Ponies | 0 | 05-12-1999 02:27 AM |