Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-06-2001, 03:20 AM
|
#2 |
|
Registered Member
Join Date: Jan 2001
Location: ny
Posts: 197
|
heres a nice little combo for ya. 351 .030 over, trw or better pistons to give 10:1 comp., zero gap rings, stock bottom end, main, rod and head studs, herbert f6j solid roller cam, roller lifters(also from herbert) , windsor sr heads with clean up, victor jr intake, 750 dp carb, roller rockers, 1 3/4 full length headers, msd dist., and all other basic stuff needed.
this setup done right will cost around 3000$ and will put you in the mid 11's. this same setup went 11.80 consistently in my car and i left the line slow. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| building a stroker need advice on solid roller or hydrallic roller cam ?? | Mustangboy89 | Windsor Power | 4 | 06-06-2003 02:10 PM |
| I need cam advice for a 351w | 82 GT | Windsor Power | 6 | 04-15-2003 11:26 AM |
| does anyone have 351w heads on a 302 block need advice | 93calcobra | Windsor Power | 7 | 12-15-2002 03:21 AM |
| building a 408 stroker need some advice | Mustangboy89 | Windsor Power | 0 | 10-19-2001 12:14 AM |
| Considering the swap to a 351W - need advice | 2FastLX | Windsor Power | 22 | 06-11-2001 06:46 PM |