Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-04-2001, 01:52 PM
|
#3 |
|
Registered Member
Join Date: Feb 2001
Location: Berkshire County - Massachusetts
Posts: 735
|
Great! So I can eliminate that off one of my potential problems list. I do have the correct serpentine setup but for a 93 5.0 I WAS using a underdrive pulley set that reduced my cooling by 20%. Another waste of money if you ask me. My engine was jumping up to 230 degrees in traffic and under 1500 rpm's, so we started troubleshooting and thought the old block and new pump was the problem. Thanks a lot. I appreciate it.
------------------ Finally DONE!! 93 GT, 393 stroker w/ Edlebrock Performer heads and EFI, 30lb injectors, Dynamic Roller Mite C4, 8 pt cage, Sothside Machine bars & Sub-frames, 3.73's, '69 351W block w/SCAT crank. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Normal Rotation Water Pump | Mustang_GT_90 | Windsor Power | 3 | 07-10-2003 10:38 AM |
| Major Problem During Water Pump Install | Evil Joe | Windsor Power | 27 | 07-10-2003 03:45 AM |
| cobra water pump pulley | DemonGT | Windsor Power | 2 | 05-19-2001 05:15 PM |
| Water pump | rj_stang | Windsor Power | 1 | 03-09-2001 10:58 AM |
| coolant leak, water pump maybe? | fiveohpatrol | Windsor Power | 4 | 02-04-2001 05:35 PM |