Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-23-2001, 10:47 PM
|
#2 |
|
Registered Member
Join Date: Sep 1999
Location: Vancouver, WA USA
Posts: 439
|
If I was in your shoes I would look at the Edelbrock ( www.edelbrock.com )performance packages. They include the cam, intake, heads, and carb. They are proven combinations that work well. Look at the Performer and Performer RPM...following the basic engine buildup then look at headers, ignition, cooling, fuel delivery, and maybe a Dr.gas "X" pipe with a 2 1/2 inch exhaust. Lots of airflow thru the motor.
Pretty basic stuff..youre in Bellevue I see...Just a bit south of you in Vancouver, WA Ron |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| rebuilding engine, will cam fit | eeh102582 | Windsor Power | 1 | 03-05-2004 02:56 PM |
| Cobra Engine Swap...Ways to improve my 98 GT... | xtrememach1racer | Modular Madness | 3 | 10-31-2002 11:23 AM |
| Rebuilding engine... | 66 Racer | Classic Mustangs | 14 | 08-05-2001 01:08 AM |
| I NEED ADVICE FOR MY ENGINE???? | Hungry4GMs | Windsor Power | 1 | 07-16-2001 08:16 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Racer's Club House | 0 | 05-12-1999 02:27 AM |