Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-26-2001, 06:21 PM
|
#8 |
|
Registered Member
Join Date: Nov 1998
Location: Houston, Tx.
Posts: 3,887
|
I think that my 351W heads, pocket ported,smoothed chambers, milled, and gasket matched with new valves with a 3 angle valve job cost under $500 including the cost of the cores.
They flow pretty well I think on a mild 302. Now I want Twisted Wedge and more top end power, but I believe I'm looking at $1800 after everything I need to do it. Rev ------------------ '66 Coupe, 306, 300 HP, C-4, 13.97 e.t., 100.3 mph 1/4 mi. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| rebuilding engine, will cam fit | eeh102582 | Windsor Power | 1 | 03-05-2004 02:56 PM |
| Cobra Engine Swap...Ways to improve my 98 GT... | xtrememach1racer | Modular Madness | 3 | 10-31-2002 11:23 AM |
| Rebuilding engine... | 66 Racer | Classic Mustangs | 14 | 08-05-2001 01:08 AM |
| I NEED ADVICE FOR MY ENGINE???? | Hungry4GMs | Windsor Power | 1 | 07-16-2001 08:16 AM |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Racer's Club House | 0 | 05-12-1999 02:27 AM |