Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-11-2001, 07:11 PM
|
#5 |
|
Guest
Posts: n/a
|
If it was going to be the same level of difficulty to put either of the 351s (W or C) in a 86 I would go with the Clevo. But I think I'm safe to say that there are quite a few more conversion kits for Windsors. Not to mention you can find Windsor parts all over. You can't say the same about Clevelands. I think Clevelands do respond to mods better, like MrWesson22 said. They are just a little harder to build. Make sure you do it right!
------------------ '69 Coupe with 351W ========================= Edelbrock Performer-RPM intake manifold, Edelbrock Performer-RPM cam, Edelbrock lifters, Edelbrock 750 cfm carb, Accel coil, Moroso Blue-Max spark plug wires, Hedman headers, 2 1/2" pipe, glasspacks, Edelbrock double roller timing chain, Edelbrock valve springs, Flex fan, C4, Lakewood traction bars, 3:1 open rear-9" 3.89:1 posi coming this summer ========================= |
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Throttle Body & Idle Conrol Valve Info | BigBobsL | Windsor Power | 2 | 02-10-2004 01:16 AM |
| Saleen Body Kits - good or bad? | subterfuge | Modular Madness | 5 | 06-26-2002 10:55 AM |
| 99-01 Gt Throttle Body 70mm Stock? | steedamustang01 | Modular Madness | 5 | 04-17-2002 11:54 PM |
| Will A Throttle Body Do Much For Ya With Minor Mods? | steedamustang01 | Modular Madness | 15 | 04-15-2002 10:38 PM |
| 351c -fox body oil pan needed | cpolka | Blue Oval Lounge | 1 | 03-20-2002 10:57 AM |