Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-12-2001, 09:37 PM
|
#2 |
|
Registered Member
Join Date: Sep 2000
Location: New Hope MN USA
Posts: 276
|
I am curious about this as well, more for the alt. Seeing a torque wrench is needed to remove this bad boy. Anyone......My ASP pulleys didn't say.
------------------ 91 LX Convertible Gray on Red B&M Shift improver kit,ASP red alum. underdrive pulleys, Richmond 3.73 gears, 1 5/8 Flowtech long tube Headers and off road h-pipe, Flowmaster 2-chamber cat-back with S.S exhaust, MSD 6A Ignition with coil,Cap and rotor, Taylor Pro wires, K&N 12" conical filter system, Jet stage 2 performance chip and just purchased some GT40P heads, looking at exhaust, Lentech Street Terminator plus on it's way... |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 68 Mustang Engine Swap pulley problems | kirkdickinson | Classic Mustangs | 10 | 07-13-2008 07:45 PM |
| FMU and Supercharger Pulley Question | NitroNixon | Windsor Power | 3 | 05-14-2003 08:06 PM |
| QUICK: What belt size for 7in crank pulley with a 3.33in charger pulley? Vortech... | JaxMustang50 | Power Adders | 0 | 05-01-2003 06:44 PM |
| Need an altenator pulley??? | Coupe Devil | Windsor Power | 4 | 04-01-2003 09:06 AM |
| Piggyback pulley problems! (long) | Mustang92 | Modular Madness | 3 | 01-16-2001 10:24 PM |