SS saw my tail lights

bri32z · 09-23-2001, 06:40 PM

Well I had a scare. Started driving down the road and I heard this awful noise....sounded like lifter about to shoot out of my engine or something to that affect. I said to myself dang just blew my new engine from getting on it too much. I really said a different word. Anyway, I pulled over and lifted the hood. All it was is the metal line coming out from the header. It must have been creased and caused it to leak real bad.(it broke in 2) I went every where to find this little pipe and no one has it. I guess I will have someone make me one up in the A.M. The bad part about it it discolored my valve cover

------------------
95 gt:edelbrock intake and heads ported and matched, 70mm throttle body, 75mm mass air meter, 2040 cam, 1.7 cobra rockers,cold air induction, bbk equal lengths,high flow h-pipe(bbk) super chip, 24lb injectors,190lph fuel pump(bbk), under drive pulleys, 3;73 gears, Has other mods but not too sure what my mechanic did. Hoping for low 11's in the 1/4 mile. Now have my 347 block installed.To see all mods look at my spec page.

My Car: <A HREF="http://www.mustangworks.com/cgi-bin/moi-display.cgi?1

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Export tail lights?	Moxie	Appearance & Detailing	2	03-02-2004 08:51 AM
Clear tail marker lights	5P0INT0	Windsor Power	7	09-10-2003 06:53 PM
Need '83-'86 Tail Lights...Again	RMARIANI	Windsor Power	1	04-13-2002 09:41 PM
Tail lights working on and off...	Badboy2777	Small Ponies	1	04-11-2002 12:08 AM
What wire gauge is used for tail lights?	Nitrous Al	Windsor Power	4	11-15-2001 08:49 PM

09-23-2001, 06:40 PM	#1
bri32z street racing junkie Join Date: Sep 2001 Posts: 231	Well I had a scare. Started driving down the road and I heard this awful noise....sounded like lifter about to shoot out of my engine or something to that affect. I said to myself dang just blew my new engine from getting on it too much. I really said a different word. Anyway, I pulled over and lifted the hood. All it was is the metal line coming out from the header. It must have been creased and caused it to leak real bad.(it broke in 2) I went every where to find this little pipe and no one has it. I guess I will have someone make me one up in the A.M. The bad part about it it discolored my valve cover ------------------ 95 gt:edelbrock intake and heads ported and matched, 70mm throttle body, 75mm mass air meter, 2040 cam, 1.7 cobra rockers,cold air induction, bbk equal lengths,high flow h-pipe(bbk) super chip, 24lb injectors,190lph fuel pump(bbk), under drive pulleys, 3;73 gears, Has other mods but not too sure what my mechanic did. Hoping for low 11's in the 1/4 mile. Now have my 347 block installed.To see all mods look at my spec page. My Car: <A HREF="http://www.mustangworks.com/cgi-bin/moi-display.cgi?1