Engine Building Tips

[Rick 91GT]

Well I can't remember the exact bolts that go into the water jackets but you can look and tell, put some sealer on them so they don't rust. Soak all the lifters in some oil before you install them. Take your time and have patience dont rush. Make sure you don't crank down on any of the gaskets too much and don't use the cork front and back manifold gaskets use a steady stream of RTV.

------------------
My Ride Check Out My Site 91GT, Holley SysteMAX II Kit-Heads 2.02" x 1.60",Full MAC exhaust 1-5/8" Long tubes, 2-1/2" O.R H-Pipe, 2 1/2" cat back, 12" K&N Filter, RNH PERFORMANCE Ram Air, Ron Davis Radiator, Full Suspension,3:73's, Welds, Best on new motor-12.60 @ 108, no traction 1.98