Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-22-2001, 01:07 AM
|
#3 |
|
Registered Member
Join Date: Sep 2000
Location: Concord, MA, USA
Posts: 264
|
I have the same problem with my 70mm TB. If you give the car a tiny bit of gas, and I mean tiny, does the idel calm? If yes, you can just drill a small whole in the TB blade. Start with the smallest bit and work your way up. You will have a higher idel, but should level it off. I have not done this to mine because I may be selling it. Maybe someone here has done it....
Good luck, Eric ------------------ 1995 GT Black sleeper Edelbrock 6037 heads,Edelbrock proformer intake,Edelbrock cam, 70mm TB,75mm pro-m mass air,Taylor wires, Underdrive pulleys,Equal length headers,K&N filter Flowmaster cat-back, Eibach pro rate springs lower control arms 3.73 gear Centerforce clutch |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
| 347 Big Time Idle problem | 89FHPLX | Windsor Power | 2 | 01-15-2002 12:02 PM |
| Problems with TFS engine combo..wont idle right and sputters when you give it throttl | dashapht | Windsor Power | 8 | 07-17-2001 12:23 AM |
| I am over the idle deal | TomEboi | Modular Madness | 3 | 03-24-2001 03:57 PM |
| 2.3 idle | matt cook | Small Ponies | 1 | 08-02-1999 04:22 PM |