Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-09-2001, 03:22 AM
|
#5 |
|
Registered Member
Join Date: Apr 1999
Location: Overland Park, KS, USA
Posts: 1,631
|
Kaufmann Products makes a good 4 cyl. to V8 swap kit.
------------------ 1984 1/2 GT350 (#842 Hatchback w/ T-tops), 302HO, Comp cams Xtreme Energy cam, Carter 625cfm carb, Weiand Stealth intake, MSD distributor, MSD coil, FMS 9mm wires, 1 5/8" MAC unequal shorties, 2 1/2" MAC Prochamber H-pipe, Flowmaster 2 chambers, KYBs, 16"x8" 4 lug Cobra Rs, Falken 245/45ZR16s So I pushed it up to 110, That flathead motor was about to give in, I crossed my fingers and prayed to the lord, Don't let me down you fuct up ford!" "5-Oh Ford" by The Reverend Horton Heat |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Very bad experience with Engine Dynamics of San Jose CA | JAGraff | Classic Mustangs | 8 | 06-16-2005 11:43 AM |
| Engine transplant across decades and models. | Sketch | Classic Mustangs | 6 | 04-18-2004 07:51 AM |
| Turbo vs SC Sounds like good advice | mustardjohn | Small Ponies | 0 | 11-16-2003 05:21 PM |
| Rebuilding an engine.. and then some | Halz | Windsor Power | 5 | 04-01-2002 02:01 AM |
| pulled engine....pulled out wallet....a true story! | 84LX89GT | Windsor Power | 6 | 03-13-2002 03:04 PM |