Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-01-2001, 03:30 PM
|
#7 |
|
Registered Member
Join Date: Feb 2001
Location: shreveport, La. USA
Posts: 27
|
try to have a torch of some kind handy. We had to superheat the pilot bearing, and the thermactor tube on the hpipe to get them out on my 93, had to chisel out the pilot on my buddys 85. be careful you dont chew up the outer edge of the socket the bearing goes into. It will be time consuming, but be patient.
 ------------------ Thomas Monahan Shreveport, La. 93Reef Blue GT BBK Ceramic Long Tubes Flowmaster 2ch system Pro 5.0 Shifter |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stalling caused by clutch? | RoushRacing6N17 | Windsor Power | 5 | 03-01-2004 08:18 AM |
| Changing clutch | Just me | Windsor Power | 10 | 10-10-2003 01:45 PM |
| My report from racing at the NMRA event in Bowling Green (was ATTN: Lt. Dan) | andy669 | Racer's Club House | 12 | 10-08-2003 02:41 PM |
| Loud "pop" after clutch install, won't go into gear.. | Chris_H | Windsor Power | 3 | 08-11-2003 06:24 PM |
| Putting in new clutch. Anything left out? | 7000rpmisheaven | Windsor Power | 5 | 12-23-2001 02:34 PM |