Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-01-2001, 09:04 AM
|
#5 |
|
Registered Member
Join Date: Oct 2000
Location: Atlanta,GA,USA
Posts: 278
|
I would only snug them down to make sure that they are flush. If would not torque them more than hand tight. While checking mine, I just set the heads on with no gasket because I now the gasket will increase clearance.
------------------ 67 Fastback - Arctic White Pearl paint 351W ,Trick Flow Aluminum Heads, Edelbrock TorkerII, Carter 750 CFM, Comp. Cam 477/510 219/233@.050, Performance Automatic C-4 Trans, 3.55 gears, Front Disc Brakes, 1-1/8" Fr. 3/4" rear sway bars. My 351W Fastback |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Any piston to valve clearance prob with AFR 165's? | 5ohCOUPE | Windsor Power | 2 | 03-09-2003 12:39 AM |
| valve seal vs piston ring oil leak. | thdrcat | Classic Mustangs | 2 | 07-30-2002 07:06 PM |
| valve clearence? | srv1 | Windsor Power | 21 | 07-25-2002 09:26 PM |
| Piston Valve Relief CC's | elmir50 | Windsor Power | 2 | 08-08-2001 12:23 AM |
| Please - I need advice on piston to valve clearance ASAP | 2FastLX | Windsor Power | 8 | 03-18-2001 03:05 PM |