Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-01-2001, 09:01 PM
|
#5 |
|
Registered Member
Join Date: Nov 2000
Location: So. Cal.
Posts: 244
|
I agree with the previous posts. I had a bronze on my 347 and after about 3000 miles it chewed. On the freeway, at about 3500 RPM. It sounded like a bomb went off. My buddy was following me and said it looked and sounded like I was shooting artilery through the exhaust.
Roller cam use steel gear (bronze if you plan on replacing it OFTEN) ------------------ 347, 279/284 .493/.510, TFS TW, Stealth, 750, Flowtech hdrs, Dr. Gas X, 2 Chmbr Flowmaster, MSD 6AL-Dist.& SS coil, Art Carr C-4, Currie 9" w/3.55, alum Drv Shft, susp mods, 4 wheel power disc In a 66 coupe |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What would make wheel bearings wear premature? | twilightcall | Windsor Power | 3 | 09-08-2003 07:25 PM |
| raced a Supra Twin Turbo | Stang35th | Stang Stories | 63 | 08-23-2003 12:36 AM |
| The Right Speedo Gear... | Titan | Modular Madness | 8 | 09-23-2002 05:42 PM |
| Rapid distributor gear wear on roller cam 351 | fxbill | Windsor Power | 5 | 01-08-2002 02:56 PM |
| new gear ratios | faststang90 | Windsor Power | 2 | 12-27-2001 03:29 AM |