Threaded Mode
© Copyright 2026 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
10-18-2001, 03:38 PM
|
#2 |
|
Sober voice of Reason
Join Date: Nov 1998
Location: Kelowna, B.C., Canada
Posts: 1,514
|
The differential cover on a 7.5 has two flat sides (top and bottom) and two curved sides, the 8.8's cover has all sides shaped the same.
Also there is a tag attached to one of the bolts of the cover that has the axle size and gear ratio. Reads something like: 7 LS 5 3 08, which means 7.5" limited slip, 3.08 gears 8 LS 8 2 73, 8.8" limited slip, 2.73 gears. ------------------ GT-40 heads (ported, polished, + milled), B303 cam, 1.7rr's, JE pistons, Offy intake, Carter AFB 625cfm carb, Flowtech 1 5/8" shortys, Flowtech X-pipe, MAC Flowpath exhaust, MAC pulleys, 373's, subframes, Eibachs+Tokicos, B&M ripper, FMS Clutch, Zoom Quadrant+cable, 17" CSA Ultra rims, 235/45ZR17 Yokohama AVS S4's, MSD 6A ignition+coil, FMS 9mm wires, Carbed, Naturally Aspirated, and Nasty! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| identifying rear ends | fordkid68 | Classic Mustangs | 8 | 07-26-2002 06:21 PM |
| rear ends | mustangman65_79 | Windsor Power | 4 | 11-24-2001 06:56 AM |
| Educate me on rear ends! | Nic92LXConv50 | Windsor Power | 3 | 08-13-2001 05:19 PM |
| How good are the 8.8 rear ends? | K.C. 5.0 | Windsor Power | 3 | 08-01-2001 06:35 PM |
| 9 inch rear ends | Fostang | Classic Mustangs | 12 | 02-19-2001 07:23 PM |