Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-05-2001, 08:18 PM
|
#8 |
|
Registered Member
Join Date: Aug 2000
Location: santa ana ca
Posts: 1,349
|
Mr.5.0 I have seen these advertized on fox bodies before where the filter was in the wheelwell but not for my SN95. Does Moroso make one for my car? All the setups I see for my car keep the filter in the engine bay with a metal plate behind it to block heat.
My friend of mine ran over a mud puddle in his integra and his fender mount cold air induction sucked up water and hydrolocked a piston. Have you ever heard of this happening to a stang? Thanks for your advice, you have been quit helpful so far  ------------------ 95GT B303 cam, 1.7 rockers, 65mm TB, 73mm MAF, milled heads, 355's K&N, off road pipes, pulleys, msd coil, 9mm wires, Tremec 3550, Pro5.0 shifter,10.5 Motorsport clutch, FMS aluminum driveshaft, weld in subframe connectors |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| WHY is a 80mm MAF and cold air induction a bad combination?? | 96_4.6 | Modular Madness | 6 | 03-09-2003 02:19 AM |
| Cold air induction | StangGT02 | Modular Madness | 5 | 07-14-2002 03:32 AM |
| Cold cold air induction!!!!!! | 01 BLACK GT | Modular Madness | 3 | 07-18-2001 02:10 PM |
| Cold Air induction.... $7.83 | rbatson | Blue Oval Lounge | 6 | 02-25-2001 01:27 AM |
| cold air induction kit | Brett_C | Small Ponies | 0 | 05-03-1999 05:34 PM |