Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
05-12-2000, 06:14 PM
|
#1 |
|
Registered Member
Join Date: Jul 1999
Location: rocky point, NY ,USA
Posts: 65
|
I've seen the Kar Kraft hood scoop on their site and I'm sure the cold air box wont be in the way and it looks like they use the stock plastic pipe from the box to the TB.The hood scoop attached to the underside of the hood might fit depending how far back it goes and how thick it is.It would probably have to be in front of the alternator to fit.If you can get some measurements from car craft, I can tell you how much room the brace takes up.Let me know how it goes cause that scoop looks interesting!
------------------ 1999 GT AOD,FMS 70MM TB,Steeda pullies,Dynomax Super Turbos,MAC cold air kit,Steeda strut tower brace,ATS-III seq. turn signals |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Strut Tower Brace | saleen243 | Windsor Power | 1 | 02-18-2003 04:52 PM |
| Will a 94GT Strut Tower Brace fit on a 99+ GT | NYC1 | Windsor Power | 0 | 12-27-2002 01:20 PM |
| Help! Strut Tower Brace - Will it fit w/this intake? | daveGT | Windsor Power | 5 | 08-05-2002 04:24 PM |
| caster/camber plates used with a strut tower brace | jtl | Windsor Power | 1 | 02-10-2002 10:31 PM |
| Strut tower brace install? | Ripper | Modular Madness | 1 | 03-28-2000 10:47 AM |