Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|||||||
|
|
Thread Tools | Rate Thread | Display Modes |
09-26-2000, 01:43 PM
|
#2 |
|
Registered Member
Join Date: May 1999
Location: Blacksburg, VA
Posts: 1,526
|
Ford and some other after-market companies have been teasing us with proto-type heads and intakes, but so far, its all show and no go. The SVO intake/heads are the only ones currently available for the SOHC. There aren't any for the DOHC.
The SVO parts do work well, but are pretty expensive. Most people just go with the 99 GT parts, which work almost as well and are a lot cheaper. Most hard-core DOHC people end up just modifying, porting, and regrinding the stock intake, heads, and cams. The Cobra block and crank really are that good. The rods and pistons need work. But there is a good after market supply of those. Aftermarket heads, cams, and intakes would be nice, but really, if worked stock parts are hitting low 10s or even 9s NA... A Cobra R style air-trumpet intake manifold would be nice though. Check out: http://www.seanhylandmotorsport.com |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What kind of Windsor heads? | vetteeatr | Windsor Power | 11 | 10-28-2001 03:43 AM |
| For whoever it was considering using stock ported heads | 2FastLX | Windsor Power | 5 | 10-11-2001 01:53 PM |
| is there any difference between 351C heads and 351M heads | tireburner163 | Windsor Power | 7 | 03-09-2001 09:26 PM |
| Is the true about Edelbrock heads with TFS intake? | gt93mustang | Windsor Power | 14 | 03-06-2001 07:01 PM |
| Which heads are beter? | patman | Classic Mustangs | 3 | 12-02-1999 03:42 AM |