Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-02-2000, 01:19 AM
|
#2 |
|
Registered Member
Join Date: May 1999
Location: Blacksburg, VA
Posts: 1,526
|
Heads (cams, springs valves, ect), intake manifold, throttle body, sprockets, timing chains, timing chain covers, computer, wiring harness, MAF, 24 lb injectors, and it goes on. And even if he does do all that, the GT short block will have lower compression, so he still won't make as much power a stock Cobra motor.
It would be a lot cheaper and easier to either one, buy a Cobra engine (http://www.seanhylandmotorsport.com is a good place to look) or to add a blower and do some work to his existing engine. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What all do you need to do rear disc conversion w/ SN95 Parts | KG88GT | Windsor Power | 1 | 07-29-2003 01:45 PM |
| questions about maf conversion | spankaveli | Windsor Power | 10 | 10-19-2002 02:46 PM |
| Sohc to Dohc | The Deuce | Modular Madness | 2 | 09-06-2002 05:28 AM |
| 4.6 SOHC vs 4.6 DOHC bolt pattern ? | rj3e5 | Modular Madness | 5 | 10-17-2001 06:06 PM |
| 4.11 or 3.73's and sohc or dohc | T-Bone | Modular Madness | 8 | 02-06-2000 08:20 PM |