Hybrid Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
02-20-2001, 05:40 PM
|
#1 |
|
Registered Member
Join Date: Oct 2000
Location: Saxonburg, PA, USA
Posts: 236
|
It's not hard really. If you open your hood and stand infront of car look down to your left. Next to where aircleaner would be you will see the ABS pump by the radiator. The Proportioning valve is right under your master cylinder, locate line between the two for front brakes. Each port will be marked to where they lead to or come from. You may need a short piece of brake line to run from out side of linelock to say ABS pump that way you dont cut and splice lines which can blow out after splicing. Then its just a matter of bleeding front brake lines and hooking wires up to a switch somewhere inside car. It will take me longer to run wires then to hook up linelock to brake line. Now I have my project for saterday
 [This message has been edited by Ares (edited 02-20-2001).] |
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hooking up elec. fan, What to do about a coolant res.? | MattwantsSpeed | Windsor Power | 6 | 10-23-2002 11:44 AM |
| hooking up sub to home receiver :D | jj_jonathon | Audio, Security, & Electronics | 2 | 09-08-2002 01:42 PM |
| hooking up a/f and voltemeter gauges... | MineralGray02K | Modular Madness | 0 | 08-03-2002 11:36 AM |
| hooking? | 89lxinwky | Windsor Power | 1 | 11-17-2001 03:43 AM |
| Lod noise, bypass and hooking up | Dominick99GT | Special Production | 0 | 12-27-2000 06:00 PM |