MustangWorks.com - The Ford Mustang Power Source!

Go Back   MustangWorks.com : Ford Forums > Mustang & Ford Tech > Modular Madness
Register FAQ Members List Calendar

Notices


Reply
 
Thread Tools Rate Thread Display Modes
Old 04-03-2001, 03:30 PM   #1
Ripper
Registered Member
 
Join Date: Jan 1999
Location: Danbury, CT, USA
Posts: 273
Smile

Since your in Texas, I would probably leave off the pullies but then definitely get a timing adjuster from Steeda. As far as shifters go, check out the Steeda Tri-ax but a lot of guys like the Pro 5.0 shifter also. Gears are going to get you into the power range (higher rpms) of your motor quicker. Your car will run a few hundred RPMs higher than your stock 3.27 gears at equivalent MPH. So, you'll likely shift gears earlier/quicker during normal driving and most guys don't see much change in their fuel economy. I wish I di this mod first but now I'm going to wait until the warranty runs. Pay attention to various posts about dealers as they do not act the same towards mods. They may say you've voided your warranty.
Ripper is offline   Reply With Quote
Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Timeslips attached/ need suggestions Kamaro Killer Blue Oval Lounge 18 12-04-2002 12:58 PM
Muffler Suggestions? zeropanic Modular Madness 9 03-11-2002 10:39 AM
Rookie upgrade"?" looking for suggestions and comments also I WTB parts if ne1 has em Rusty45398 Windsor Power 9 11-21-2001 02:19 AM


All times are GMT -5. The time now is 07:50 AM.


SEARCH