Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-08-2001, 02:03 PM
|
#2 |
|
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
WELCOME BACK BUD
 Glad everyone was OK after that accident!Don't know what to tell you about oil in the intake if it's not coming from the PCV. I am having problem but it was due to bad heads and a cam that didn't pull S**T for vacuum. Where does the PCV hook up to on the E'brock? You could install a filter in the PCV line to rule it out as well? ------------------ My Ride Check Out My Site 91GT, Holley SysteMAX II Kit-Heads 2.02" x 1.60",Full MAC exhaust 1-5/8" Long tubes, 2-1/2" O.R H-Pipe, 2 1/2" cat back, 12" K&N Filter, RNH PERFORMANCE Ram Air, Ron Davis Radiator, Full Suspension,3:73's, Welds, Best on new motor-12.60 @ 108, no traction 1.98 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Intake selection with a 383/408 stroker | Capri306 | Windsor Power | 12 | 05-03-2002 10:12 PM |
| Explore intake??????????? | William Bowers | Windsor Power | 2 | 02-14-2002 10:27 PM |
| HELP!!! oil in intake, what to do?? | bosco | Windsor Power | 4 | 02-03-2002 05:02 PM |
| Edelbrock spec's and intake question?? | jerryIII | Windsor Power | 0 | 05-24-2001 12:49 PM |
| Is the true about Edelbrock heads with TFS intake? | gt93mustang | Windsor Power | 14 | 03-06-2001 07:01 PM |