Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-29-2001, 05:18 PM
|
#3 |
|
Registered Member
Join Date: Aug 2000
Location: carrollton, tx, USA
Posts: 15
|
it's actually between 280 and 281 but most people round up. so i say get 281
------------------ 97 Mustang GT Rio Red 99 port/polish heads,99 cams,99 intake manifold,Steeda sport springs,Steeda caster/camber plates,Offset steering rack bushings,Steeda subframe connectors,Tokico struts/shocks,Steeda Triax shifter,FRPP clutch,FRPP 3.73 Gears,Pro-M 87 mm mass air,K&N filter,FRPP underdrive pullies,FRPP 9mm plug wires,Steeda timing adjuster,MSD DIS-4 ignition,Aeromotive adjustable fuel pressure regulator,Walbro 190 lph fuel pump,FRPP shorty headers,Bassani offroad x-pipe,Mac cat-back exha |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| going turbocharged which cubic inch motor to build | Mustangboy89 | Windsor Power | 24 | 07-07-2003 12:45 AM |
| 3 inch piping | 01whtegt | Modular Madness | 3 | 08-15-2002 12:26 PM |
| are mac's 3 1/2 inch tail pipes for my setup | Chevysucks | Windsor Power | 1 | 03-18-2002 03:46 PM |
| Gettin' there inch by inch... | Stefan | Modular Madness | 2 | 05-08-2001 04:01 PM |
| horse power and cubic inch size | speedie66 | Classic Mustangs | 3 | 06-27-2000 07:30 PM |