

© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
![]() |
#2 |
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
![]() I have the Stewart and it works great my car never goes over 180 degrees, I have a Ron Davis Radiator, Flex fan (switching to Perma-Cool electric while the motor is out) and 195 degree thermostat. My Stewart was $69.00 for the un-polished version.
You don't need a alt upgrade to run a electric fan either, so I would go with a electric model if you can, but the stock set-up works really well from what I have been told. ------------------ My Ride Check Out My Site 91GT, Holley SysteMAX II Kit-Heads 2.02" x 1.60",Full MAC exhaust 1-5/8" Long tubes, 2-1/2" O.R H-Pipe, 2 1/2" cat back, 12" K&N Filter, RNH PERFORMANCE Ram Air, Ron Davis Radiator, Full Suspension,3:73's, Welds, Best on new motor-12.60 @ 108, no traction 1.98 |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Edelbrock RPM Package | jim_howard_pdx | Classic Mustangs | 2 | 10-28-2002 04:57 PM |
Edelbrock garbage | Stang951 | Windsor Power | 8 | 06-16-2001 08:21 AM |
Edelbrock Upper W/ Truck Lower?? | IMPULSERACING | Windsor Power | 2 | 04-16-2001 02:05 PM |
Is the true about Edelbrock heads with TFS intake? | gt93mustang | Windsor Power | 14 | 03-06-2001 07:01 PM |