Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-20-2001, 10:56 AM
|
#9 |
|
Registered Member
Join Date: Sep 2000
Location: Concord, MA, USA
Posts: 264
|
You should talk to a pro engine builder. 450-500 is way too much to expect with that set up. Check out this site www.golensengineservice.com see what the're using to make 450-500. Give them a call or e-mail if you have questions about the custom projects they do. I'm trying to save some money and have them build a 450hp 351. Good luck with the motor!
------------------ 1995 GT Black sleeper Edelbrock 6037 heads,Edelbrock proformer intake,Edelbrock cam, 70mm TB,75mm pro-m mass air,Taylor wires, Underdrive pulleys,Equal length headers,K&N filter Flowmaster cat-back, Eibach pro rate springs lower control arms 3.73 gear Centerforce clutch |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Built Motor? Questions | Rosco | Windsor Power | 1 | 10-22-2003 01:12 AM |
| Non-H.O Motor question(s)?........ | gtsr515 | Windsor Power | 2 | 02-01-2003 10:33 AM |
| Rebuilding an engine.. and then some | Halz | Windsor Power | 5 | 04-01-2002 02:01 AM |
| What year and type of motor do I have.. | Smokedawg | Windsor Power | 18 | 08-15-2001 05:08 PM |
| GT-40p headed motor | 89 Cobra LX | Windsor Power | 5 | 06-15-2001 06:46 PM |