Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-18-2001, 05:00 PM
|
#2 |
|
Registered Member
Join Date: Oct 2000
Location: Saxonburg, PA, USA
Posts: 236
|
Yep your in luck, Canton Racing Products makes a very nice one that they also supply Ford with for the 2000 Cobra R.
P/N 15-784 baffled same as used on Cobra R P/N 15-780 non baffled They also make a screen/windage tray for the 4.6/5.4 P/N 20-939 4.6 tray P/N 20-939C 5.4 tray used on Cobra R (203)481-9460 Canton Racing Products 232 Branford Rd. No. Branford, CT. 06471 ------------------ 2000 GT Laser red-5speed,MAC Cold Air, MAC 2 1/2" Cat-Back, 3.27gears, Pro-5.0 shifter, Weld Draglite's 15x5 and 15x10, 275/50-15 DragT/A's, 165R15 front, BBK Underdrive pullies, BBK offroad X-pipe with Dynomax super converters Best Quarter mile run to date: 13.350@101.79/1.844 60'(7-6-01)Best MPH 101.79(7-6-01) [This message has been edited by Ares (edited 07-18-2001).] |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| AFtermarket or factory fender | 7up | Windsor Power | 13 | 08-19-2002 11:30 PM |
| Aftermarket 289/302 Water Necks | DJs350H | Classic Mustangs | 8 | 05-12-2002 02:47 PM |
| Those with Vortech's and aftermarket deep sump pans come inside... | Nutty 5.0 | Windsor Power | 3 | 06-25-2001 08:35 PM |
| 67 Convertible Floor Pans | Gichigumi | Classic Mustangs | 0 | 06-14-2001 04:12 PM |
| Aftermarket 4.6 Heads & Manifolds & Blocks...WHERE ARE THEY!! got any ideas? | Shawn | Modular Madness | 3 | 09-26-2000 02:07 PM |