Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-02-2001, 12:46 PM
|
#2 |
|
Registered Member
Join Date: Dec 1999
Location: Warrington, PA
Posts: 694
|
Get a light port and polish, and a 3-5 angle valve job if you are shooting for 300HP. YOu'll probably need some long tube headers too. I think 300HP is possible with the stock PI intake, but you might need a Bullitt intake also.
11:1 should be fine with 93-94 octane. You should have a good dyno tune performed though. 11:1 will be a bit much though if you plan any forced induction. You could always have the heads worked to drop the CR if you plan FI in the long term. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GT40 head swap help | Falcons Talon | Windsor Power | 8 | 04-01-2004 09:10 AM |
| Head Swap finally Done | Badass_yellowGT | Modular Madness | 3 | 11-14-2002 02:34 AM |
| Head swap question | Badass_yellowGT | Modular Madness | 11 | 11-04-2002 11:19 PM |
| Thinking of 99 head swap? BEWARE... | 97ScottieGT | Modular Madness | 7 | 03-14-2002 01:43 PM |
| those with '96-98 motors and want a head swap. | Ares | Modular Madness | 6 | 01-18-2002 10:30 AM |