It's new, and just for you!

stangsrule · 12-02-1999, 03:11 PM

Thanks Dan!!! You are THE MAN!!! I think this is a great idea! I am not a roadracer yet but am working towards that goal. My question is what do you guys recommend for a good but not too expensive brake upgrade. I really want the Baer kit but it is a little expensive and then I run into the problem of added cost, cause if I go that route I would be tempted to go 13in in the front and that would mean new rims and then I would have 4 lug in the back and 5 in the front..... trying to do it in steps cause of cost and all. So I can't make up my mind. I have the Maximum Motorsports brake upgrade kit and it helps but isn't enough for my taste. Any and all opinions and info is welcome.
Thanks!!

------------------
92GT all the free stuff and a few bolt-ons, lowered with Ebiach's and Koni's, Kenny Brown subframe connectors, lower G-brace and jacking rails. BBK upper and lower control arms, polyurethane bushings all around and Ken Bell blower, ram-air, 80mm mass air, etc.

[This message has been edited by stangsrule (edited 12-02-1999).]

12-02-1999, 03:11 PM	#2
stangsrule Registered Member Join Date: May 1999 Location: Indiana Posts: 512	Thanks Dan!!! You are THE MAN!!! I think this is a great idea! I am not a roadracer yet but am working towards that goal. My question is what do you guys recommend for a good but not too expensive brake upgrade. I really want the Baer kit but it is a little expensive and then I run into the problem of added cost, cause if I go that route I would be tempted to go 13in in the front and that would mean new rims and then I would have 4 lug in the back and 5 in the front..... trying to do it in steps cause of cost and all. So I can't make up my mind. I have the Maximum Motorsports brake upgrade kit and it helps but isn't enough for my taste. Any and all opinions and info is welcome. Thanks!! ------------------ 92GT all the free stuff and a few bolt-ons, lowered with Ebiach's and Koni's, Kenny Brown subframe connectors, lower G-brace and jacking rails. BBK upper and lower control arms, polyurethane bushings all around and Ken Bell blower, ram-air, 80mm mass air, etc. [This message has been edited by stangsrule (edited 12-02-1999).]