
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
#2 |
|
Registered Member
Join Date: Feb 1999
Location: Caracas, Venezuela
Posts: 81
|
that depends on your type of racing and place to be raced
I've used 4.10 last year for our peculiar type of solo, a friend of mine even ran on 4.36 When tried the car at the open circuit did found that it was to short and 4th and 6000 rpm was way too far from turn one and had to shift to 5th and that is a total waste of time, cause shift time is to big and it doesn't matter the gear you use the hole between 4th adn 5th is too big. Planning to get back to 3.73 as soon as get receive my torsen lito ------------------ 92GT, SOLO RACER, COBRA BRAKES, R1 TIRES, GT40, GT40X HEADS 58CC, 24LBS, 70MM/65MM, E303, MAC 1"5/8 LT HEADERS, 3" XPIPE AND EXHAUST W/CUT OFFS, 4.10, H&R 950-1050 SPRINGS, BILSTEIN SHOCKS, MM PANHARD AND TA, MANY ROAD RACE MODS, CORVETTE, CAMARO, RX7 AND SUPRA SOLO EVENT EATER www.killersracing.com www.clubcopa.com <IMG SRC="http://www.killersracing.com/lito/mustan |
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear end problems - OUCH! | mysweetlx | Windsor Power | 0 | 09-23-2002 01:40 PM |
| Recommendations on a rear gear ratio | jim_howard_pdx | Windsor Power | 1 | 09-15-2002 12:10 AM |
| question on fuel system and rear gears and launching | vetteeatr | Windsor Power | 1 | 08-12-2001 05:28 PM |
| Gears, need help!!!! | Edgar Negron | Windsor Power | 3 | 05-27-2001 03:10 PM |
| Recall 01S15 Rear Knuckle replacement | folthoff | Special Production | 0 | 05-02-2001 08:28 AM |
