Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-08-2001, 12:40 AM
|
#2 |
|
Registered Member
Join Date: Jan 2001
Location: Fremont, Ca, USA
Posts: 4
|
Hi,
Hold off on the hammer.. I'm looking at the service manual for my 95 Cobra and it says that the Rear brake anti-lock sensor must be torqued to 40-60 lb-in when installed. (I'm assuming it is not pressed in if it requires to be torqued when re-installed) It warns that the sensor must come out before the axle is removed. The whole section on the rear end shows a long list of specialty tools needed for disassembly and re-assembly.. Good luck guys. ------------------ Cobra-95 Coupe BLK/BLK, K&N,MSD6AL,Griggs spings,coil-over kit,sub/f, Tokico 5 way Shocks and Struts. |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SN-92,SN-93,GSS Paxton Ball-Drive Guys Step INSIDE | Mustanguy | Windsor Power | 4 | 02-13-2006 12:13 PM |
| Quick question!! Need help fast please!... Steering wheel question!!!... | WA2FAST | Windsor Power | 3 | 02-14-2002 02:41 PM |
| Is it me? Or do you Guys have the same problem? (Girls can help me on this too) | 1969Mach1 | Blue Oval Lounge | 26 | 12-02-2001 01:04 AM |
| Here is the deal with the GM guys at work | bri32z | Stang Stories | 22 | 11-27-2001 01:34 PM |
| Attn 351W guys | 1988gtconv | Windsor Power | 9 | 01-11-2001 10:37 PM |