Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-13-2001, 09:47 AM
|
#4 |
|
Procharged!
Join Date: May 1999
Location: Hanover, PA
Posts: 1,539
|
I currently shift at 6250 since I was limited by the factory rev limitier. I am going to 4:30 gears so I should be going through the line around 6350 or so. My car is still pulling when I shift at 6250,m I think I couls get a little more rpm out of it.
------------------ My Ride Check Out My Site 91GT, Holley SysteMAX II Kit-Heads 2.02" x 1.60",Full MAC exhaust 1-5/8" Long tubes, 2-1/2" O.R H-Pipe, 2 1/2" cat back, 12" K&N Filter, RNH PERFORMANCE Ram Air, Ron Davis Radiator, Full Suspension,3:73's, Welds, Best on new motor-12.60 @ 108, no traction 1.98 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
| building a stroker need advice on solid roller or hydrallic roller cam ?? | Mustangboy89 | Windsor Power | 4 | 06-06-2003 02:10 PM |
| Solid Roller ? | STROKER BILLY | Windsor Power | 5 | 11-19-2002 12:04 AM |
| 351W roller conversion | Capri306 | Windsor Power | 4 | 02-14-2002 04:49 PM |
| hydraulic roller valvetrain for HP street?? | Stang_ROTY | Windsor Power | 2 | 04-27-2001 01:09 AM |