Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-13-2001, 03:29 PM
|
#5 |
|
I need 110mph Trap Speed!
Join Date: Feb 1999
Location: So, CA
Posts: 4,315
|
My car is dead by 6000.
5000- 306rwhp 5200- 319rwhp 5500- 332rwhp 5700- 323rwhp 5900- 310rwhp 6000- 300rwhp I didnt go past that on the dyno. So maybe your cam wil rev a lot higher than that. But I'd check first to see. ------------------ -1989 Saleen Mustang #406- TFS Heads, E-303, edelbrock intake,70MM TB, 73mm MAF, off road H, 2 1/4" exhaust, and 4.10's. 332RWHP@5500 351RWTQ@3750 Runs on 87 Octane! |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
| building a stroker need advice on solid roller or hydrallic roller cam ?? | Mustangboy89 | Windsor Power | 4 | 06-06-2003 02:10 PM |
| Solid Roller ? | STROKER BILLY | Windsor Power | 5 | 11-19-2002 12:04 AM |
| 351W roller conversion | Capri306 | Windsor Power | 4 | 02-14-2002 04:49 PM |
| hydraulic roller valvetrain for HP street?? | Stang_ROTY | Windsor Power | 2 | 04-27-2001 01:09 AM |