Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
01-09-2001, 04:42 AM
|
#14 |
|
Registered Member
Join Date: Jul 2000
Location: San Jose CA
Posts: 149
|
$500 is very expensive, I agree. The problem is I am in the middle of buffing my stock upper and lower and am not real keen on doing this again on a Cobra Intake. Probably am going to have to however, as the cost of extrude honing far exceeds the cost of a used Cobra.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Intake Manifold ID | Nixon1 | Windsor Power | 4 | 02-01-2003 11:00 PM |
| Questions about hoses connected to stock intake | zepherman | Windsor Power | 14 | 09-13-2002 05:05 AM |
| (Where can I/What is) a good intake manifold? | Sonics2042 | Windsor Power | 11 | 12-27-2001 05:48 PM |
| how crazy can you make a stock intake?? | LX XLR8R | Windsor Power | 9 | 09-10-2001 10:11 PM |
| Ported Stock Intake HP??? | BowTie Eater 5 Liter | Windsor Power | 13 | 03-22-2001 01:07 AM |